[product name]: 12V new boat type adjustable high and low temperature electric heating handle[product material]: PET metal heating filmProduct size: Length: 9.5CM; Width: 8cmInput voltage: 12V[Product power]: 10W (one-sided power) 20W on both sides[Handle temperature]: low temperature: 30; high temperature 50-60[Switch Type]: Three-speed adjustable switch[Product accessories]: left and right handle * pair, heat shrinkable sleeve * pair; waterproof insulating tape * 1; manual * 1[Applicable models]: 12V all motorcycle modelsProduct advantages:[1] The product adopts a simple modification method, that is, it does not damage the appearance, is easy to operate, and is very easy to install. [2] The product material is made of PET metal heating film, the heating speed is very fast, and it heats up in a few seconds, which is safe and fast. [3] The product design adopts a three-speed adjustable switch, one gear, two gears, off, you can adjust the high and low temperature according to your own needs, the design is very user-friendly [4] The product switch adopts the design of the rearview mirror fixing bracket, which can be directly installed on the rearview mirror mirror seat, without drilling or damage, it is very simple and convenient [5] As long as the product is a motorcycle with a voltage of DC12V input, it can be used, and the range of use is very wide. installation method:1: Put the heater on the handlebar and adjust it to the proper position[2]: Use tape to evenly fix (wrap) the heater on the handlebar, especially at the wiring of the heater, wrap tightly [3]: Put on the casing, adjust the position, use a hot air gun (you can also use a lighter or a hair dryer) to blow the two folds of the outer casing longitudinally symmetrically until the shrinkage is uniform, and then blow other parts evenly until the outer casing. All parts of the tube shrink evenly and flat 4: The switch is installed under the mirror rod of the rearview mirror 5: Connect the power cord, the red line and the black line are not divided into positive and negative poles, but they must be connected to the lower output line of the electric door lock (where the key is inserted). Product Include 1 x Heated grip pads (with connection wires and on/off switch) 2 x Heat resistant covers 1 x Adhesive tape