Key benefits Durable construction: Thickened pipe and support plate plus a slightly widened face plate distribute load and resist wear during long term use. Reinforced strength: Two extra supporting struts and a lengthened central strut provide added rigidity to prevent bending or breakage. Secure hold: Built in cable tie attachment keeps hoses from sliding loose and reduces sideways sagging. Reliable performance: Designed to keep intake jets aligned, support pool pumps, and hold filter hoses in an elevated position to improve flow and reduce stress on connections. What it does and why you need it Prevents hose sagging and misalignment that can reduce pump efficiency and cause stress on fittings. Stabilizes hoses and pipes against the pool wall so connections remain secure and jets point where they should. Adds structural support for external pump and filter lines, reducing maintenance and the risk of hose kinks. Key features Compatibility: Fits most water pipes and hoses with diameters from 30 mm to 38 mm. Material: Made from durable ABS for stable, long lasting use. Design details: Thickened pipe and support plate, widened face plate, two additional support struts, and a lengthened middle strut for extra strength. Anti slip: Cable tie attachment prevents the pipe from sliding out of the holder. Simple mounting: Uses the pool plugs to isolate water, remove the hose, and press the hose holder against the pool wall before securing. Typical use scenarios Aboveground pool with external filter pump: Hold the filter hose off the ground and keep the hose aligned to the pump inlet to prevent kinks and improve flow. Skimmer or jet alignment: Straighten intake or jets by stabilizing the hose path and keeping fittings from twisting. Seasonal pool maintenance: Support hoses during winter storage or when adjusting plumbing, preventing sideways sagging and reducing stress on connectors. Installation overview Stop water flow with the pool plugs supplied with the pool. Remove the hose from its connection. Position the hose holder so the widened face plate presses against the pool wall. Reattach the hose into the holder and use the included cable tie for extra security. Apply the included adhesive where needed for added stability. Specification Material: ABS Fits pipe diameter: 30 mm to 38 mm Packing list 1 x Pipe Holder 1 x Tie 1 x Adhesive This pipe holder is a practical accessory for keeping pool hoses and pipes supported, aligned, and secure during regular operation and maintenance.