USBJZSPCMS02 Programming and Debugging Cable Key benefits Direct USB connection between a PC and compatible servo drives for programming, parameter setup, and diagnostics. Simplifies commissioning and troubleshooting by enabling reliable data transfer and access to drive status and error information. Saves setup time and reduces risk of configuration errors during tuning and maintenance. What it does Provides a USB interface for debugging and programming SigmaII and SigmaIII models SGDH, SGDS, SGDM, and SGDJ. Facilitates reading and writing of parameters, firmware updates where supported by the drive software, and live monitoring during testing. Compatibility and function Designed specifically for use with SigmaII and SigmaIII servo model families SGDH, SGDS, SGDM, and SGDJ. Acts as the communication link between PCbased drive tools and servo controllers for configuration and diagnostics. Performance and build USBbased connection for stable serial communication with servo controllers. Engineered for reliable operation in control and maintenance workflows where repeatable data exchange is required. Typical applications Commissioning and tuning: connect a laptop to the drive to set motor parameters, adjust control gains, and verify motion profiles during initial setup. Onsite troubleshooting: access drive diagnostic information and error codes to isolate faults and restore operation more quickly. Software updates and configuration management: apply parameter changes or updates during planned maintenance or system upgrades. Why choose this cable Purposebuilt for the listed servo models to ensure proper connection and communication between PC tools and drives. Useful for engineers and technicians responsible for configuring, maintaining, and troubleshooting industrial motion control systems. Compatibility note Intended for use with SigmaII and SigmaIII model range SGDH, SGDS, SGDM, and SGDJ. Confirm drive compatibility with your control software before use.