Fridge and Freezer Screw In Foot Adjustable Leg 40mm Equivalent to Part Number 2230099174 Model identification and compatibility See the list below for the full range of models this part fits. The model number is normally found inside the fridge or freezer. You will likely need to remove the salad drawer or freezer drawer to access the model number plate. If not present there, the model number is often on the side or rear of the appliance. The model number is typically printed or stamped on a sticker or plate and will consist of a mix of numbers and letters. Compatible models (examples): EEN3441JOW, EN12900AW, EN12900AX, EN13201JW, EN13201JX, EN13400AW, EN13400AX, EN13445JW, EN13445JX, EN13455MX, EN13600AX, EN13601JW, EN13601JX, EN14000AW, EN14000AX, EN2900ADW, EN2900ADX, EN2900AOW, EN2900AOX, EN3011JOW, EN3011JOX, EN3200AOW, EN3201JOW, EN3201JOX, EN3201MKW, EN3201MOW, EN3201MOX, EN3209MFW, EN3209MFX, EN3211MOW, EN3211MOX, EN3214JOW, EN3214JOX, EN3230COX, EN3240AOW, EN3241AOW, EN3241AOX, EN3241JOW, EN3241JOX, EN3400ADW, EN3400ADX, EN3400AOW, EN3400AOX, EN3409AFW, EN3430COW What this part does Provides an adjustable 40mm screwin leg to stabilize and level a fridge or freezer. Replaces a damaged or worn foot to restore appliance balance and prevent rocking. How to use Screw the leg into the appliance base until it is firmly seated. Adjust by turning the leg to raise or lower the height as needed to achieve level positioning. Ensure the appliance stands steady on the floor with doors closing properly. Practical use scenarios Scenario 1: Leveling a fridge on an uneven kitchen floor after installation to ensure a proper door seal and reduce vibration. Scenario 2: Replacing a broken foot on an aging fridge to restore stability and prevent wobbling. Scenario 3: Compensating for a slightly tilted floor in a kitchen remodel, so the appliance remains level without replacing the entire base.