Measures 0 to 60 V and is compatible with 12 V, 24 V, 36 V and 48 V battery bank systems. Precision AluChrom current sensing resistor (0.001 Ω) with circuitry that draws only 7 mA, enabling accurate, lowdraw measurements. AllInOne Meter: convenient to calculate voltage, current, power, discharge amount and discharge time of the aircraft, which is convenient for calculating the force effect of the multiaxis aircraft. A reliable troubleshooting tool for analyzing, testing and troubleshooting any DIY DC power project. Benefits and performance Broad voltage compatibility allows use across common battery configurations (12/24/36/48 V) without additional adapters. precision current sensing with a 0.001 Ω resistor minimizes measurement error in lowresistance paths. Low idle current (7 mA) reduces load on the system under test, preserving battery life during measurements. AllinOne capability consolidates multiple measurements into a single tool, simplifying power analysis for aircraft and multiaxis platforms. Strong suitability for DIY and hobbyist DC power projects, supporting rapid testing, validation, and troubleshooting. Key specifications and attributes Voltage range: 0–60 V Battery compatibility: 12 V, 24 V, 36 V, 48 V banks Current sensing resistor: AluChrom, 0.001 Ω Power draw of sensor circuitry: 7 mA Functionality: voltage, current, power, discharge amount, discharge time calculations for aircraft systems Use scenarios Drone or multiaxis aircraft power management: monitor voltage and current while estimating discharge time and forcerelated performance to optimize flight characteristics. DIY DC power projects: analyze and verify voltage, current and power in custom power rails, wiring, and components during build and testing. Battery bank evaluation and bench testing: quickly assess system health and discharge behavior across common 12/24/36/48 V configurations.