Replacement part for power navigation light controller designed for RC FPV setups. Controls reflector LED and offers dual switch operation with steady and strobe modes. Rated for use with 2S to 4S LiPo battery systems and supports up to 3A load. Key benefits Restores lighting function quickly: a damaged or lost controller to get navigation lights and spotlight control working again. Versatile control options: dual switch operation provides both steady illumination and strobe patterns for visibility and signaling. Matches common RC power systems: compatible with 2S, 3S, and 4S LiPo battery setups used in many RC FPV craft. Suitable for power LEDs: supports up to 3A, making it appropriate for brighter navigation lights and reflector LEDs. What it does Acts as a direct replacement part for power navigation light controllers used in RC FPV applications. Controls LED reflector and navigation lights with dual switch selection between steady output and intermittent strobe. Operates within the 24S LiPo voltage range and is rated for a 3A load to handle power LED demands. Compatibility and fit Intended for RC FPV aircraft and other RC models that use 24S LiPo systems and a separate navigation light controller. Use as a spare or replacement in builds where a controller with dual switch strobe and steady modes is required. Performance highlights Voltage compatibility: 2S to 4S LiPo battery range. Current rating: up to 3A output to support power LED loads. Functionality: supports steady and strobe lighting modes via dual switch control. Practical use scenarios after impact: a broken navigation light controller on an FPV drone to restore night flight visibility and compliance with lighting requirements. Night flying upgrade: install as a replacement in an RC airplane to regain reliable steady and strobe lighting for better orientation and visibility. Multi platform lighting control: use on RC boats or ground vehicles that need a compact controller for a power reflector LED and selectable strobe function. Notes for buyers Sold as a replacement controller component for compatible power navigation light systems in RC FPV and similar models. Verify your model uses a 24S LiPo power source and that a 3A rated controller meets your LED load requirements before .