100 percent brand hot surface ignitor replacement, fully tested and quality controlled before shipment. Designed as a direct replacement part to restore reliable ignition in compatible gas heating equipment. Key benefits Restores ignition function for furnaces and heaters by replacing a failed or worn hot surface ignitor. Tested and quality controlled prior to shipment to reduce the risk of early failure. Direct fit for matching part numbers to simplify replacement and reduce downtime. Supplied as a single complete ignitor unit so replacement is straightforward when parts match. Compatibility and replaced part numbers Replaces part numbers: for PP200, HA1000, 10254801, 10254802, 10254803, 10254804, 10254805, 10254806, 10254807, PP200SC Fits models from AllPro, Desa, Dayton, John Deere, Master, ProCom, Reddy, Remington, Sears and many other models that use these part numbers. Confirm part number and appearance before ordering to ensure proper fit. Package contents 1x Hot Surface Ignitor Replacement as pictured Performance and use Function: provides the hot surface element needed to ignite gas fuel in compatible heating equipment. Performance: supplied and tested to deliver consistent ignition when installed in compatible units. Installation: intended as a direct replacement for the listed part numbers. Compare the old part to the replacement for alignment and connection compatibility. Professional or qualified installation is recommended if user is not familiar with appliance service. Practical use scenarios a failed ignitor in a garage or workshop heater to restore reliable starting for seasonal use. Maintain or service portable and heaters before peak usage to avoid unexpected downtime. Swap a worn ignitor during routine equipment maintenance for models that list one of the replaced part numbers. Notes Verify the part number and visual match with the existing ignitor prior to installation. This listing includes one replacement ignitor only.