Protective mud flaps splash guards designed to match your vehicle’s original contours and keep paint, underbody, and trim cleaner and safer. Key benefits Non-destructive installation: No drilling needed. Each flap is cut so the curvature and pre-drilled holes perfectly match the original car for a direct fit. Clear protection: Shields lower panels and wheel arches from mud, rocks, salt, and road spray to reduce chips, corrosion, and cleaning frequency. Durable construction: Made from sturdy ABS thermoplastic that is flexible enough to absorb impacts and rigid enough to resist deformation from harsh road hazards. Seamless appearance: Contoured design complements vehicle lines and adds a neat, subtle styling enhancement that suits a sporty or factory look. Compatibility and fit Specifically designed for Land Rover For Discovery4 For Discovery3 models, years 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016. Precision-cut to match original wheel well shape and mounting points for reliable alignment and consistent performance. Performance and attributes Material: ABS thermoplastic — corrosion-resistant, impact-tolerant, and UV-stable for long-term use. Function: Redirects road debris and water away from bodywork, helping preserve paint and reduce maintenance. Design: Contoured to follow vehicle lines so protection does not compromise appearance. Practical use scenarios Weekend off-road driving: Protect lower body panels from gravel, stones, and mud when driving on trails or rural roads. Wet-weather commuting: Minimize road spray and splash onto the vehicle and following traffic during heavy rain. Winter driving: Reduce salt and slush contact with wheel arches and underbody to help slow corrosion and simplify cleaning. What you can expect A direct-fit set of splash guards engineered to match the original car’s cut, curvature, and hole locations. Long-lasting ABS construction that balances flexibility and strength for everyday road conditions. Installation note No drilling required — designed to install using existing mounting points and matching hole patterns for a non-destructive fit.