The Kramer TP-590TXR is a high performance, extended-reach HDBaseT 2.0 transmitter for 4K60Hz (4:2:0) HDMI, USB, Ethernet, RS-232, IR and stereo audio signals over twisted pair. The Kramer TP-590TXR converts all input signals into the transmitted HDBaseT 2.0 signal. It extends video signals to up 100m (330ft) over CAT copper cables at up to 4K@60Hz (4:2:0) 24bpp video resolution and provides even further reach for lower HD video resolutions. Comes with UK KETLE LEAD Kramer TP-590TXR Specifications Connectivity Inputs 1 - HDMI on an HDMI connector, 1 - Stereo Analogue unbalanced audio on a 3.5mm mini jack Outputs 1 - HDBaseT on an RJ-45 female connector Ports 1 - IR on a 3.5mm mini jack for IR link extension, 1 - USB 2.0 on a USB-B connector, 1 - RS-232 on a 3-pin terminal block for serial link extension, 1 - RS-232 on a 3-pin terminal block for device control, 1 - 10Base-T/100BaseTx Ethernet on an RJ-45 female connector for device control and network traffic extension HDBaseT Specifications Extension Line HDBaseT 2.0 compliant Up to 100m (330ft) at 4K @60Hz (4:2:0) Up to 130m (430ft) at full HD (1080p @60Hz 36bpp) Up to 180m (590ft) at HDBaseT ultra mode and full HD (1080p @60Hz 24bpp) Note: When using Kramer HDBaseT cables Video Up to 10.2Gbps bandwidth (3.4Gbps per graphic channel) Up to 4K UHD @60Hz (4:2:0) 24bpp resolution HDCP 1.4 signal compliance Supports deep colour, x.v.colour, lip sync, HDMI uncompressed audio channels, Dolby TrueHD, DTS-HD, 2K, 4K, and 3D as specified in HDMI 2.0 Audio Up to 1 Vrms level 0.03% THD + NOISE @ 1 KHz at nominal level Extended USB 1.1 and 2.0 Host compliance Up to 127Mbps (out of max 480 USB) extended line rate bandwidth Up to 7 devices Up to 2 hubs Up to 8 ports per hub Extended Ethernet Up to 100Mbps extended line rate bandwidth Extended RS-232 300 - to 115200 baud rate Control RS-232 115200 - baud rate Supported Web Browsers Windows 7 and higher: Internet Explorer (32/64 bit) version 11,