Precision 12 mm Hole Component This part is designed for applications that require a precise 12 mm hole diameter. It provides a reliable passage or mounting point for fasteners, shafts, bushings, and similar components that match a 12 mm size. Key benefits Exact fit: The 12 mm hole diameter ensures consistent alignment with 12 mm bolts, rods, or sleeves, reducing play and improving assembly accuracy. Simplifies installation: A correctly sized hole speeds up assembly and replacement tasks by eliminating guesswork and trimming. Versatile compatibility: Fits a wide range of mechanical and structural applications where a 12 mm clearance or mounting hole is required. Improved performance: Proper fit helps maintain alignment and load transfer, supporting stable operation in mechanical assemblies. Important attributes Size: Hole diameter 12 mm. Confirm any additional outer or thickness dimensions with the product listing before ordering. Function: Provides a dedicated opening for mounting, fastening, guiding, or passing a 12 mm component. Compatibility: Suited for bolts, shafts, spacers, bushings, cable glands, or fittings that require a 12 mm hole diameter. Material and finish: Verify material and finish options on the product listing to match application requirements such as strength, corrosion resistance, or electrical properties. Performance considerations: For tight tolerances or rotating applications, confirm fit tolerance and clearance specifications with the seller to ensure operation. Practical use scenarios Mechanical repairs: a worn or mismatched mounting plate or washer in machinery that uses 12 mm bolts to restore proper alignment and secure fastening. DIY and fabrication: Use as a predrilled mounting point in custom brackets, panels, or enclosures where a 12 mm fastener or guide needs to pass through. Vehicle and equipment maintenance: Install as a spacer or guide for components that accept a 12 mm shaft or fastener during routine maintenance or retrofits. Installation tips Measure the mating component to confirm it is 12 mm in diameter before installation. Check the product listing for material, thickness, and tolerance details to ensure suitability for load and environmental conditions. If a snug or sliding fit is required, verify clearance specifications and consider using appropriate washers, bushings, or lubricants as needed. This component is intended for use where a 12 mm hole diameter is required. Confirm any additional dimensional or material requirements in the product listing to ensure full compatibility with your application.