Color: A Compact brass angle stop valve with pushin connection and handle, G1/2 Description A pushin angle stop valve designed for quick, tool installation and reliable flow control of hot and cold water. The valve uses a pushfit connection so no soldering, clamps, or glue are required. Brass construction offers temperature ductility and long service life. The valve can be disconnected in seconds with a disconnecting clamp, disassembled and reused, and rotated after assembly to simplify installation in tight spaces. Key benefits Fast installation: pushin fitting accepts the pipe by hand, eliminating soldering, clamps, and glue. Quick serviceability: disconnect the connection in seconds with a disconnecting clamp; valve can be removed, reused, or rotated after installation. Durable material: brass construction resists breakage under normal operating temperatures. Simple flow control: on/off handle for easy shut down of water to fixtures during maintenance or . Versatile application: suitable for potable water lines and hydronic heating systems. Features Connection type: pushin angle stop valve with G1/2 thread Material: brass component Handle color/type: Blue/Redness Compact size: approximately 32 x 80 mm 3.15 x 1.26 inch Reusable and rotatable after assembly for easy alignment in confined spaces No soldering, clamps, or adhesives required for the initial installation Package includes one stop valve Typical use scenarios Undersink shut off: install on the cold or hot supply line to a kitchen or bathroom sink to isolate the fixture for without shutting off the building main. Toilet supply isolation: use as a local shut off for toilet supply lines for quick maintenance or replacement. Hydronic heating branch control: install on circuit branches to isolate radiators or heating loops during service. Notes Please allow 1 to 2 cm variation due to manual measurement. Actual item color may vary slightly from the image depending on monitor settings.