GLXFLORP 15 foot Cable Flow Switch Assembly Reliable flow switch assembly designed as a direct replacement for salt chlorine generator systems that require positive water flow detection. Key benefits Protects your salt cell operation by detecting adequate water flow before the cell runs, helping prevent dry running and premature wear. 15 foot cable provides flexible mounting options and easier routing to control boxes or equipment pads. Simple replacement design reduces installation time for pool technicians and DIY installers. Durable construction suited for pool equipment environments for consistent daytoday performance. Direct compatibility with commonly used salt chlorination systems, making it a practical spare part for maintenance and repairs. What it does Monitors pool water flow and signals the control system when flow is present, ensuring the salt cell only operates under safe flow conditions. Acts as a straightforward flow sensor replacement to restore normal system operation when an original flow switch fails. Compatibility and size Model: GLXFLORP with 15 foot cable. Compatible with Hayward and Goldline Aquarite salt systems, including Hayward Salt Cell and salt chlorine generator systems. Compact sensor assembly with a long lead cable to reach controller locations without requiring extensions. Installation and performance notes Designed for straightforward swapin replacement; confirm wiring and controller connections match your equipment before installation. Route the 15 foot cable away from heat areas and sharp edges. Turn off power to the system before replacing the flow switch. After installation, verify the system recognizes flow and that the salt cell operates only when water is flowing. Typical use scenarios a failed factory flow switch on a salt chlorine generator to restore automated operation and avoid manual system overrides. Keep as a spare onsite during seasonal startup or routine maintenance to minimize downtime if the original switch fails. Use when upgrading or servicing pool equipment where a longer cable run is needed between the flow sensor location and the control module. Choose this GLXFLORP 15 foot cable flow switch assembly when you need a reliable replacement part that restores proper flow sensing for salt cell and salt chlorine generator systems compatible with Hayward and Goldline Aquarite equipment.