3 pin extension cable for mid drive brake levers, thumb throttle, gear sensors. Cable length: 22 inches (56 cm). Key benefits - Extends wiring to fit your e-bike layout without forcing component placement - Supports mid drive brake levers, thumb throttles, and gear sensors with a standard 3-pin connection - Simple, plug-and-play compatibility to reduce installation time - Helps maintain clean routing and reduce cable strain on handlebars and frame Compatibility and specs - Connector type: 3-pin extension - Applications: mid drive brake levers, thumb throttles, gear sensors - Length: 22 inches (56 cm) - Designed to work with standard 3-pin systems used in common e-bike components What makes it practical - Easy to route along the frame or handlebars to accommodate new setups or rearranged components - Useful for upgrades, repairs, or custom builds where original cables are too short - Keeps signal and power connections intact while providing flexibility in placement Use scenarios - Scenario 1: Replacing a short factory cable during a mid-drive upgrade and needing extra length to route wiring safely along the frame - Scenario 2: Installing a new larger handlebar setup or reconfiguring cockpit controls that require extended throttle or brake lever wiring - Scenario 3: Building or modifying an e-bike where gear sensor wiring must reach a different position without stressing the connector Notes - This description reflects a standard 3-pin extension cable intended for mid drive brake levers, thumb throttles, and gear sensors with a 22 inch (56 cm) length.