RN01 Magnetic Hands Alignment Magnetic hands alignment: Builtin magnet in the base grips ferrous metals such as saw blades, steel beams, and fixtures for steady positioning while you work. Enables quick setups on miter saws, table saws, drill press tables, and pipe runs without juggling extra clamps. The RN01 is compact and lightweight, sits solidly yet moves easily to the next task, and makes angle setting simpler in shops, job sites, and home projects. Easy readout and data hold: Large LCD with easytoread numerals shows angles at a glance in low light or when mounted overhead. Data Hold freezes the reading so you can reposition or record values without losing track. Ideal for calibration checks, cabinetry alignment, and machine setup in tight spots where you need to view the number without changing the tool's position. Dual modes and anywhere use: Switch between absolute angle and relative angle to compare two parts or reference a baseline. Can be set at any position to create custom references on saw blades, workbenches, or jigs, speeding repeat cuts and ensuring consistent layouts for woodworking, metal fabrication, and installation tasks. Move between tools and keep the same reference for repeatable results. Wide range with accurate resolution: Measures across four 90degree quadrants with ±0.3° accuracy and 0.05° resolution, providing fine control for bevels, chamfers, miters, and leveling. Read small changes confidently when dialing in fence angles or fixture tilt, and verify angles on tools, rails, and frames before committing to a cut or weld. Suitable for builds, site work, and DIY projects. Practical applications Set precise angles quickly on a miter saw or table saw during trim, molding, or cabinetry projects. Calibrate and align jigs and fixtures, then repeat cuts with the same reference across multiple tools. Onsite alignment of pipe runs or fixture tilts for installation or welding tasks, ensuring consistent layouts.