This hydraulic press is a multipurpose tool designed for dental laboratories and dental technician offices as a modern substitute for older manual presses. It provides controlled hydraulic pressure for pressing flasks and similar laboratory tasks, improving convenience and reducing manual effort. Key benefits Simplifies pressing tasks by using hydraulic force instead of manual methods, reducing physical effort and speeding routine work. Allows simultaneous pressure application to three flasks while showing current pressure on the barometer, enabling consistent and repeatable results. Easy to operate with no special equipment required and automatic piston when the pressure valve is opened. Flexible and efficient for laboratory workflows and smallbatch production. Main features and performance Intended use: pressing and compressing tasks in dental technician offices and dental laboratories. Hydraulic output: system can exceed 15 MPa. Commonly used operating pressure is around 20 MPa. Do not exceed the pressure range of the gauge to avoid damage. Controls: manual pressure switch and hydraulic rod for pressure adjustment, pressure pole for securing the dental box, and a pressure valve for release. Visibility: builtin barometer displays applied pressure during operation. Operation behavior: opening the pressure valve causes the piston to to its initial position automatically. Typical applications Pressing investment flasks for casting and model work in dental laboratories. Replacing older manual presses in dental technician offices for tasks that require controlled pressure. Smallscale production runs where consistent, repeatable pressure is needed across multiple flasks. Operation steps 1. Pull the pressure switch to the pressurerising position. 2. Adjust the platform height as needed. 3. Place the compression component and press the pressure pole to fix the dental box. 4. Use the hydraulic rod to increase pressure while monitoring the barometer. 5. Pull out the pressure switch to reduce pressure, then release the pressure pole to remove the box. Packing list Hydraulic press x1 Rod x1 Reline jig x1 Important note The hydraulic system output can be more than 15 MPa; commonly used pressure is around 20 MPa. Do not exceed the pressure range indicated by the gauge to prevent damage to the gauge or other system components. Compatibility and requirements Designed for use in dental laboratories and dental technician offices. No additional special equipment is required for basic operation.