Captype current slip ring with outer diameter 22 mm, 2way, rated 30 A This slip ring is a captype solution designed to transfer power across a rotating joint while protecting the conductors from dust and debris. Its compact 22 mm outer diameter makes it suitable for tight spaces in small to mid sized rotating assemblies. The 2way configuration provides two independent paths for power transfer, supporting up to a 30 A current rating. The captype design helps shield the contact area, helping to reduce contamination and simplify maintenance in challenging environments. Key attributes Type: Captype current slip ring Outer diameter: 22 mm Configuration: 2way (two channels) Current rating: 30 A Protection: Captype design with protective cap to shield contacts Suitability: Compact form factor for small rotating assemblies requiring two separate current paths Functionality and performance Enables continuous power transfer across a rotating joint without cable twisting Two independent circuits provide flexible wiring options for power delivery Captype protection helps minimize ingress of dust and particulates at the contact interface Designed for reliable operation in applications where space is limited and a twochannel, current solution is required Compatibility and integration Intended for use in compact rotating assemblies where an outer diameter of 22 mm is suitable Twochannel configuration supports parallel power routing for compact machinery Captype design offers added protection at the contact interface, potentially reducing maintenance frequency Recommended use cases Robotic arms and automation platforms with rotating joints that require two separate power paths and up to 30 A Small to medium sized surveillance cameras, rotating platforms, or dynamic mounts needing consistent power supply to motors and actuators Compact wind or solar tracking systems and rotary stages where a twochannel power transfer solution is advantageous Installation and usage notes Ensure the installation space accommodates the 22 mm outer diameter and the captype protective geometry Do not exceed the rated current of 30 A for the slip ring Route wiring to minimize mechanical stress and avoid sharp bends near the contact interface Verify proper alignment of the rotating parts to prevent contact wear and ensure smooth operation This captype current slip ring delivers a compact, twochannel solution for transmitting power through rotating joints at up to 30 A. Its small form factor and protective cap design make it suitable for compact applications that demand reliable power transfer with minimal maintenance.