This listing is for 6 piece/s.DRY PTFE LUBE FG is a multi purpose dry film PTFE lubricant suitable for use in food processing industries. The lubricant is NSF H1 registered (No. 139899) and forms a clean - dry film with effective anti-stick properties - low environmental dust/dirt adherence and good resistance to water - oils and solvents. APPLICATIONS Forms a dry - non-toxic colourless film for the light lubrication of: Chutes Slides Pins and More Particularly suitable in low load low speed applications. Apply a light - even coating from 6 - 10 inches (15 - 25 cm). Re-apply as necessary. Caution: Do not smoke during the use of this product and avoid the contamination of tobacco. If sprayed onto hot surfaces or if the coating is heated (over 230C) ensure local exhaust ventilation is applied and avoid inhalation of fumes. Wash hands well after use. TECHNICAL DATA Appearance : Colourless - opaque dry film Odour : Mild hydrocarbon solvent SG @ 20C : 0.730 Pressure @ 20C : 3.5 bar Discharge rate @ 20C : 1.0-1.2 g/sec Temperature range : Operational from -100C to +200C Solubility : Insoluble in water and most solvents. Flammability : Classified as extremely flammable under current EC Regulations Flashpoint : Not applicable in sealed aerosol Packaging : 400 ml aerosol Based upon the present state of our knowledge and information received from our suppliers - evaluation of this product indicates that it is free from nut oils and their derivatives. STORAGE The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame. Pack of 6