65ft Black BNC Video and Power Cable for Lorex LW84W LHD44 LHV414 Cameras Keep your security cameras connected and powered with a single reliable cable. This 65ft black video and power lead uses a BNC video connector and dedicated power conductor to simplify installation and maintain stable signal and power over a common run length. Key benefits Simplifies installation: One cable carries both video and power, reducing cable runs and connection points. Reliable signal and power: Coaxial video conductor with an insulated power wire helps maintain consistent video quality and camera operation at the full 65ft length. Clean, discreet routing: Black jacket blends with typical indoor and outdoor camera installations for a tidy look. Replacement and expansion ready: Designed for direct use with compatible camera systems to worn cables or extend existing setups. Important attributes Function: Combined video and power cable with BNC video connector and power lead for CCTV camera connections. Compatibility: Compatible with Lorex LW84W LHD44 LHV414 camera models and other systems that use BNC video connections and separate power leads. Size: 65 feet total length for flexible placement and longer cable runs without additional adapters. Construction and performance: Coaxial video conductor paired with an insulated power wire and a black protective jacket for everyday durability and straightforward installation. Practical use scenarios Backyard camera installation: Run a single 65ft cable from an outdoor camera to a nearby recorder or power source mounted inside the house, keeping connections consolidated. Replacement for damaged runs: Swap in this cable to restore video and power to an existing Lorexcompatible camera without rewiring the entire system. Garage or detached structure setup: Feed video and power from a DVR and power supply inside a garage or shed to a camera mounted on the exterior or a nearby pole. Installation notes Connect the BNC end to the camera video input and the matching BNC on the recorder or extension. Attach the power lead to the camera power input and the power source using the correct polarity and connector type for your camera. Verify compatibility with your camera model and power supply before installation. This 65ft black BNC video and power cable provides a straightforward, tidy solution for connecting and powering compatible surveillance cameras.