L60A 60A PWM Solar Charge Controller Overview The L60A is a 60 amp PWM solar charge controller for 12V and 24V systems. It uses an intelligent PWM charging algorithm and a builtin industrial microcontroller to manage solar panel and battery operation automatically. The controller improves charging efficiency and reduces standby power draw while providing comprehensive protections and an easy to read LCD interface. Key benefits Higher charging efficiency: PWM charging with automatic maximum power point tracking increases charging efficiency by 10 to 30 percent compared to ordinary controllers. Low standby consumption: standby current is only 10 to 15 mA, cutting idle energy use by over 30 percent versus typical controllers. Reliable battery care: 3stage PWM charge management and automatic temperature compensation prolong battery life and maintain full battery status. Simple setup and control: LCD display and intuitive interface make monitoring and parameter configuration straightforward. Main features Model and compatibility: L60A, compatible with 12V and 24V battery systems, automatic voltage recognition. Current capacity: 60A charge rating. Supports simultaneous charge and discharge. USB charging: 5V USB output available for mobile charging, model dependent, up to 2.5A. Intelligent PWM charging: improves conversion efficiency and battery charge quality with three stage charge control. Threeperiod time control: programmable evening work period, pause period, and dawn work period. Times A, B and C are user adjustable to match lighting schedules. LCD display: shows operating status and system data, with easy mode switching and parameter reset. Manual controls: onekey load on and off, onekey factory reset. Protections: battery reverse discharge protection, reverse polarity protection, undervoltage protection, overload protection, shortcircuit protection, and opencircuit protection. Temperature compensation: automatic adjustment to charging parameters based on temperature. Automatic shutdown: if battery voltage falls below 10V, the controller will disconnect the load to protect battery lifespan. Low standby energy use and efficient operation to reduce energy waste. Technical notes and safe installation tips Always connect the battery first, then connect the solar panel. Disconnect in the reverse . Ensure the battery has sufficient voltage so the controller can detect the battery type. If you need an inverter, connect it directly to the battery, not to the controller load output. Install a fuse on the battery positive line sized at 1.25 to 2 times the controller rated current. Place the fuse within 150 mm of the battery terminal. Package contents 1 x L60A PWM Solar Controller 1 x English User Manual 1 x Temperature Sensor Typical applications Offgrid cabin or remote lighting systems where efficient charging and low standby consumption extend battery life and reduce maintenance. RV, caravan or boat solar systems to manage battery charging and provide a USB charging port for devices. Small commercial or industrial outdoor installations for lighting control and battery management with programmable evening and dawn schedules. What this controller solves Prevents overcharge and deep discharge to lengthen battery life. Reduces wasted energy when the system is idle. Simplifies solar system setup and operation with clear status display and programmable time modes. Protects system components with comprehensive electrical protections. This L60A controller combines robust protection, programmable timing, and efficient PWM charging to deliver reliable battery management for a wide range of 12V and 24V solar applications.