Color: 24v Product summary A compact, IP67rated controller designed for wind turbine charging systems. Supports 12 V, 24 V, and 48 V battery systems and provides automatic voltage detection, overcharge protection, and both automatic and manual braking for the wind generator. Key benefits Protects batteries and wind generator by automatically stopping charging when the battery is fully charged or input voltage is too , and resuming charging when conditions to normal. Simplifies installation with clear wiring steps and a manual brake option for maintenance or emergency stop. Durable and weatherproof design with a wide operating temperature range for reliable outdoor use. Main features and specifications Battery rated voltage: 12 V, 24 V, 48 V Wind rated power: 2000 W Protection level: IP67 (dust tight and water resistant) Size: 92 x 84 x 19 mm Weight: 255 g Operating temperature range: 35 C to 70 C Status indicators: three LEDs to show system condition and charging status Automatic battery voltage detection to apply the correct charging parameters Automatic braking when battery is fully charged or when input voltage is too , with automatic recovery when input voltage falls Wiring and installation 1. Connect the battery positive and negative to the controller battery positive and negative terminals. 2. Connect the wind turbine threephase output to the controller threephase input terminals. 3. To activate manual brake, short the thin red wire to the battery positive terminal. To cancel manual brake, disconnect the thin red wire. Package contents 1 x Controller Typical applications Offgrid wind power for remote cabins and small homes using 12 V, 24 V, or 48 V battery banks. Hybrid renewable systems where a wind turbine charges a battery bank alongside other generation sources. Remote equipment sites such as weather stations, telecommunications repeaters, or monitoring stations that require autonomous wind charging and reliable protection. Notes and compatibility Designed for use with threephase wind turbine outputs and battery systems within the rated voltages. The manual brake wire must be connected only when the battery positive is available and secured. Follow local electrical codes and safe installation practices when wiring and mounting the controller.