Professional air hammer and needle scaler for commercial or occasional use This listing is for both a 190mm air hammer with chisels as well as a needle scaler attachment AIR HAMMER DESCRIPTION190mm air hammer and chiselsIdeal for general cutting requirements, chipping and scraping Delivers hard hitting hammeringErgonomic design with rubber protective handles for comfort and grip when using the toolBuilt in power regulator and trigger controlCoil spring retainer for fast and easy chisel changesComes complete with 5 different chisels for wide variety of usesCHISELS INCLUDED1. 1 x taper punch 2. 1 x ripping chisel3. 1 x tailpipe cutting chisel4. 1 x spot weld breaker chisel5. 1 x coil spring chisel retainerSPECIFICATIONS• 190mm air hammer with grip• 5.5 CFM (requirement) • 1/4in. Air inlet (complete with quick release PCL type fitting) • 90 PSI air pressure• 3000 BPM• 10.18mm chisel shank• 5 x different air chiselsNEEDLE SCALER DESCRIPTIONVery useful tool suitable for removing paint, rust etc... Suitable for use on heavier work such as wheels, engine blocks, chassis rails and box sections.Fits 150mm and 190mm Air chisels/hammers as well as the one supplied in this listing Screw on design. Tighten the Allen key grub screws to attach and remove. Loosen during use. (Please note, Allen key pictured is not included)This attachment is made up of approximately 19 needles which chip away at the surface.This tool is suitable for removing rust and paint, it screws on the end of a standard size air chisel gun. SPECIFICATIONS• To be used with an air chisel gun • Heavy duty steel casing • Knurled ring • Black oxide finish to prevent corrosion • 230mm length • 30mm diameter (inner) • 50mm (outer)