Y1 12V to 24V 2A Boost Voltage Regulator — NonIsolated A compact, reliable boost converter designed to step a 12V DC source up to a regulated 24V DC output at up to 2A. The Y1 model is ideal when you need to run 24V equipment from a 12V battery or system without replacing existing power sources. Because it is nonisolated, it uses a common ground between input and output—this keeps the design simple and efficient for many automotive, marine, and industrial applications. Key benefits Converts a 12V DC supply to a stable 24V DC output, allowing seamless use of 24V devices from 12V systems. 2A rated output delivers up to 48W of power for low to midpower devices. Nonisolated design simplifies wiring and reduces cost where isolation is not required. Compact form factor and straightforward wiring make it quick to install and integrate. Main features and specifications Model: Y1 Function: Boost (stepup) voltage regulator / power converter Input: 12V DC (designed for 12V systems) Output: 24V DC Maximum output current: 2A (maximum continuous) Isolation: Nonisolated (input and output share common ground) Suitable for powering 24V loads up to 48W Compatibility and performance notes Intended for use where input and output share a common ground; not suitable for applications that require galvanic isolation between input and output. Rated output current is 2A — verify device startup and peak currents, as motors or capacitive loads can draw higher transient currents. Ensure adequate ventilation or mounting to provide cooling under continuous loads near the 2A limit. Typical use cases Power 24V LED strips or lighting modules from a 12V vehicle battery when you need highervoltage LED drivers without rewiring the vehicle electrical system. Run 24V control electronics, sensors, or communication equipment in cars, boats, RVs, or offgrid 12V battery systems. Provide a 24V supply for industrial or hobby circuits (PLC modules, relays, GPS/telemetry devices) where isolation is not required and current demand stays within 2A. Installation and safety tips Confirm the input is a stable 12V DC source and that the load will not exceed 2A continuous. Because the converter is nonisolated, tie grounds appropriately and avoid connecting systems that require isolation. Check wiring and connectors for proper current rating; use appropriate fusing on the input to protect against short circuits. Allow airflow around the converter when running near maximum rated current to prevent overheating. The Y1 12V to 24V 2A nonisolated boost converter offers a straightforward, effective solution for powering 24V devices from 12V systems when isolation is not required. Use it to extend the capabilities of vehicles, boats, RVs, and small equipment with a reliable stepup voltage regulator.