Higher switching capacity for reliable performance: a 10 ampere switch with a longer service life compared to typical replacements, designed to handle higher load demands in power tools. Broad compatibility: intended as a replacement for Marquardt 0102, 1281.0115 and Kopp MS2 2412.56 switches. Suitable for use in drills, circular saws, thread cutting brackets, and other compatible equipment. Important installation note: before installation, verify the contact assignment of the switch with a continuity test and compare it to the old switch. This helps prevent incorrect connections and potential equipment damage. Size and fit guidance: the dimensions shown in the second picture are for orientation and may vary slightly. These variations do not affect the usability of the switch replacement. Practical use scenarios: Replacing a worn or failing switch in a handheld drill to restore reliable on/off control. Upgrading a circular saw switch to improve current handling and reduce switch wear under load. Replacing the switch in a thread cutting bracket or similar power tool where a 10 A rating and compatible form factor are required. Key attributes at a glance: current capability (10 A), compatibility with specified Marquardt and Kopp models, clear installation verification steps, and orientationbased dimensional guidance to ensure proper fit.